-
Federal
Dynamic compressive stress-strain curves of aluminum alloy 6061-T6 with rapid heating
National Institute of Standards and Technology —
This dataset contains raw mechanical data (strain, stress and strain rate curvesand initial temperatures) for compression experiments performed on aluminum alloy... -
Federal
Data for NIST Technical Note: Validation and Optimization with a Vapor Compression Cycle Model Accounting for Refrigerant Thermodynamic and Transport Properties
National Institute of Standards and Technology —
This data set includes (1) Experimental measurements, and (2) Simulation data. The experimental data set shows raw measurements and important calculated parameters.... -
Federal
AM Bench 2022 challenge Macroscale Tensile Tests at Different Orientations (CHAL-AMB2022-04-MaTTO)
National Institute of Standards and Technology —
Additively manufactured (AM) laser powder bed fusion (PBF-L) Inconel 625 blocks were built with two different scan strategies: XY and X-only. 96 tensile specimens... -
Federal
Optical n(p, T_90) measurement suite 2: H_2O and D_2O
National Institute of Standards and Technology —
Supplementary data for the article "Optical n(p, T_{90}) measurement suite 2: H_2O and D_2O" in International Journal of Thermophysics, by P.F Egan and Y. Yang.The... -
Federal
In situ thermography of the metal bridge structures fabricated for the 2018 Additive Manufacturing Benchmark Test Series (AM-Bench 2018)
National Institute of Standards and Technology —
These measurements were performed as part of the 2018 Additive Manufacturing Benchmark Test Series (AM-Bench). This dataset and the associated experiments are part of... -
Federal
Supporting information to accompany: Super-Ancillary Equations for Cubic Equations of State
National Institute of Standards and Technology —
Supplementary files to accompany the the paper "Super-Ancillary Equations for Cubic Equations of State" of Ian Bell and Ulrich Deiters in Ind. Eng. Chem. Res.... -
Federal
Spin Excitations in Co3V2O8. Raw data files from neutron spectroscopy experiments using the DCS spectrometer at the NCNR to probe the spin fluctuation spectrum of Co3V2O8.
National Institute of Standards and Technology —
A series of neutron spectroscopy measurements were performed on two single crystal samples of Co3V2O8 using the Disk Chopper Spectrometer (DCS) time-of-flight neutron... -
Federal
Data to accompany the paper "Comparison of Heat Capacity Measurements of Alternative and Conventional Aviation Fuels"
National Institute of Standards and Technology —
The data are averaged specific heat capacity measurement results and associated expanded uncertainties for nine conventional and alternative aviation fuels (Jet A,... -
Federal
Aged and unaged flexible unidirectional composite laminate tensile testing for soft body armor applications
National Institute of Standards and Technology —
Flexible Unidirectional (UD) composite laminates are commonly being used for ballistic-resistant body armor. These laminates comprise UD layers, each constructed by... -
Federal
AM Bench 2022 challenge problem Subcontinuum Mesoscale Tensile Test (CHAL-AMB2022-04-MeTT)
National Institute of Standards and Technology —
One additively manufactured (AM) laser powder bed fusion (PBF-L) Inconel 625 mesoscale tensile specimen (gauge dimensions approximately 0.2mm x 0.2 mm x 1mm) was... -
Federal
A Dynamic Plasticity Model for Rapidly-Heated 1045 Steel up to 1000 °C
National Institute of Standards and Technology —
This dataset contains raw mechanical data (strain, stress and strain rate curves and initial temperatures) for compression experiments performed on annealed 1045... -
Federal
ANDiE: the Autonomous Neutron Diffraction Explorer.
National Institute of Standards and Technology —
ANDiE the Autonomous Neutron Diffraction Explorer is a tool for autonomously discovering the magnetic transition temperature and transition dynamics of a material... -
Federal
Temperature measurements of experiments to characterize the influence of walls, corners and enclosures on fire plumes.
National Institute of Standards and Technology —
The data is from two series of compartment fire experiments in which a natural gas burner is positioned in a corner, or against a wall, or inside a steel cabinet, to... -
Federal
CMOS Sky130 Primitives measured at cryogenic temperatures
National Institute of Standards and Technology —
Sky130 is an open source complimentary metal oxide semiconductor (CMOS) technology manufactured by Skywater Technology in its facility in Bloomington, Minnesota.... -
Federal
Data from Fire Resilience of a Steel-Concrete Composite Floor System: Full-Scale Experimental Evaluation for Influence of Slab Reinforcement (Test #1)
National Institute of Standards and Technology —
The compartment fire test was conducted on the 9.1 m x 6.1 m steel-concrete composite floor, located in the south-central bay of the two-story steel gravity frame two... -
Federal
Data from: Collaborative Guarded-Hot-Plate Tests between the Laboratoire national de métrologie et d'essais and the National Institute of Standards and Technology
National Institute of Standards and Technology —
A collaborative study to compare the long-term measurement performance between guarded-hot-plate facilities at the Laboratoire national de métrologie et d'essais... -
Federal
Optical n(p, T_90) measurement suite 1: He, Ar, and N_2
National Institute of Standards and Technology —
Supplemental material to the article "Optical n(p, T_90) measurement suite 1: He, Ar, and N_2" by PF Egan and Y Yang in International Journal of Thermophysics... -
Federal
Software and Data associated with "Binding, Brightness, or Noise? Extracting Temperature-dependent Properties of Dye Bound to DNA"
National Institute of Standards and Technology —
The purpose of this software and data is to enable reproduction and facilitate extension of the computational results associated with the following referenceDeJaco,... -
Federal
Thermal Conductivity of Binary Mixtures of 1,1,1,2-Tetrafluoroethane(R-134a), 2,3,3,3-Tetrafluoropropene (R-1234yf), and trans-1,3,3,3-Tetrafluoropropene (R-1234ze(E)) Refrigerants
National Institute of Standards and Technology —
Workflow: The data that falls into this category are gathered from a measurement program and are published in the archival literature. -
Federal
PROperties of FIre Suppressant SYstems: "PROFISSY" - A Spreadsheet Application for Fire-Suppressant Bottle-Filling Calculations
National Institute of Standards and Technology —
This spreadsheet and accompanying files are the result of work performed for U.S. Army Ground Vehicle Systems Center by the National Institute of Standards and...