Skip to main content
U.S. flag

An official website of the United States government

Constant vs. cyclic flow when testing face masks and respirators as source control devices for simulated respiratory aerosols

Published by Centers for Disease Control and Prevention | U.S. Department of Health & Human Services | Catalog Last Checked: September 10, 2026 at 08:15 PM | Dataset Last Updated: September 09, 2026
SARS-CoV-2 spreads by infectious aerosols and droplets expelled from the respiratory tract. Masks and respirators can reduce the transmission of infectious respiratory diseases like SARS-CoV-2 by blocking these aerosols and droplets at the source. The ability of source control devices to block aerosols can be tested by expelling an aerosol through a headform wearing the device. These tests may be performed using constant airflows, which are simpler, or cyclic airflows, which are more realistic but require more complex methods. The purpose of these experiments was to compare the results found using constant vs. cyclic airflows. A source control measurement system was used to measure the efficacy of two cloth face masks, two medical masks with and without an elastic mask brace, a neck gaiter, and an N95 respirator as source control devices for simulated respiratory aerosols. With this system, the aerosol flows from the inside of the mask toward the outside; that is, the aerosol flows in the same direction as it would flow during an exhalation by a person wearing the source control device. The experiments were conducted under four airflow conditions: cyclic breathing at 15 liters/minute (L/min), cyclic breathing at 85 L/min, constant outward airflow at 15 L/min, and constant outward airflow at 85 L/min. Each experiment began by placing the source control device on the headform and performing a fit test. The measurement system collection chamber was then sealed, and the cyclic or constant airflow and the aerosol generation were initiated. The aerosol concentration in the collection chamber was measured using an optical particle spectrometer (OPS). The source control collection efficiency was determined by comparing the steady-state concentration of aerosol particles in the collection chamber when the source control device was worn with the concentration when no source control device was used.

Resources

1 resource available

Find Related Datasets

Search by Tags

Click any tag below to search for similar datasets

data.gov

An official website of the GSA's Technology Transformation Services

Looking for U.S. government information and services?
Visit USA.gov