-
Federal
Utah FORGE: Targeting Geothermal Resources with Geodetic Strain Data Paper
Department of Energy —
The paper linked below offers an initial assessment of a new method to target potential geothermal resources on the regional scale. The method is based on seeking... -
Federal
STRESSINVERSE Software for Stress Inversion
Department of Energy —
The STRESSINVERSE code uses an iterative method to find the nodal planes most consistent with the stress field given fault frictional properties. STRESINVERSE inverts... -
Federal
Utah FORGE: Updated Discrete Fracture Network Model - 2025
Department of Energy —
The Utah FORGE 2025 v1 DFN (fracture model) includes 131 discrete planar fractures which were identified using combined site data sets to capture flow pathways... -
Federal
EGS Collab Experiment 1: Accelerometer orientations
Department of Energy —
Document describing the methodology used to determine the accelerometers' three-component orientations at the first EGS Collab testbed using Continuous Active-Source... -
Federal
BOBr Raw Breaking Wave Data, Agate Beach, OR
Department of Energy —
Raw data from the BOBr (Buoy to Observe Breaking) wave measurement buoy. Data was recorded off the coast of Newport, OR at Agate Beach, in the surf zone. -
Federal
BOBr Processed Breaking Wave Data, Agate Beach, OR
Department of Energy —
This data was recorded by the BOBr (Buoy to Observe Breaking) off the coast of Newport, OR at Agate Beach in the surf zone. The data was recorded by a 9dof inertial...